With the improvement of quality of life, the amount of domestic sewage treatment is gradually increasing, which requires the application of integrated water reuse equipment to solve the problem. However, it is also necessary to pay attention to daily inspections. So today, let's learn from the editor what must be inspected for integrated water reuse equipment.

The integrated reclaimed water reuse equipment adopts the cutting-edge membrane bioreactor technology, which makes the effluent water of the system software better than traditional wastewater treatment equipment in various fields. The effluent water is close to drinking water in appearance and can be reused as reclaimed water, occupying a small total area. Due to the high efficiency of the membrane, it does not need to shape heterogeneous equipment such as sedimentation and filtration, does not require backwashing, and the suspended solid concentration value in the effluent is much lower than that of traditional heterogeneous equipment. This makes the steps of the system software simple, easy to integrate, and the area occupied by the system software significantly reduced.

Here is a brief and detailed introduction to the inspection of integrated water reuse equipment before trial operation. We look forward to providing some assistance to everyone.

1. The actual operator checks the tightening condition of the screw cap on the bolt and the connecting bolt between the motor shaft and the centrifugal fan base.

2. Check the lubrication condition of the rolling bearings of the integrated water reuse equipment and the tightening condition of the rolling bearing bolts.

3. Check if the radial sealing packing (packing) is tightened and if the pipeline leading to the exhaust valve ring in the water pump seal is connected to the diameter.

4. Special tools and raw materials for maintenance must be readily available. When the water flow rate is insufficient or the capacity of the water receiving location is limited, it is necessary to discuss and adjust the plan with relevant departments to obtain consistency, which facilitates all normal and continuous trial operations. When the coal mine centrifugal water pump is first tested, special attention should be paid to avoiding suspended solids in the water tank from being sucked into the pump and damaging the centrifugal impeller.

5. Check that the integrated water reuse equipment is equipped with pressure gauges, safety protection equipment, and motor control equipment, which should be flexible, accurate, and reliable.

专业水处理的疑难问题，产品选型问题，可以单击下面的微信二维码电话联系贺工在线指导，长按微信二维码可自动识别添加贺工微信沟通解决您的疑难问题