Reverse osmosis equipment, also known as RO reverse osmosis water purification equipment, RO reverse osmosis water purification equipment, RO reverse osmosis sewage treatment equipment, RO reverse osmosis sewage treatment equipment, RO pure water equipment, and so on. The common characteristic is that there are many pores on the reverse osmosis semi permeable membrane that are the same size as water, because bacteria, virus infections, most organic chemical air pollutants, and hydrated ions are much larger than water, they cannot be separated from water through the reverse osmosis semi permeable membrane. Soluble salts are residues that are difficult to remove from water. Therefore, the actual effect of water purification by reverse osmosis equipment depends on the desalination rate, and the key to desalination rate lies in the selectivity of the reverse osmosis semi permeable membrane. Membrane screening components have good selectivity, with a desalination rate of 99.7%

In the metallurgical industry, light industry, electroplating process and other fields, reverse osmosis equipment has the ability to separate chemical substance concentration values and moisture content. To avoid economic losses caused by common failures of reverse osmosis equipment, appropriate operating steps should be adopted. So, how to effectively operate reverse osmosis equipment to reduce equipment failure rate?

1. Non wastewater treatment equipment operators and managers are not allowed to enter or exit the wastewater treatment production line casually.

2. It is strictly prohibited for untrained operators to open wastewater treatment equipment.

3. After starting up, the actual operation personnel should not change positions casually and pay attention to the operation status of the system software anytime and anywhere;

4. The actual operation personnel of the reverse osmosis equipment must record various statistical data such as pressure, flow rate, pressure, startup, standby, and clearance time of the equipment operation on a daily basis.

5. The software equipment of the reverse osmosis equipment system is prohibited from operating with common faults. Once any abnormal situation is found in the system software equipment, the equipment operation should be immediately interrupted, and the responsible person should be notified to lead the way. Technical professionals and agents should conduct common fault inspections.

6. To start the activated carbon filter equipment, the filter valve should be opened first, followed by the inlet valve (the automatic exhaust valve can be closed when the exhaust pipe is completed). After the water quality of the lower filter valve is qualified, the water valve should be opened, and the lower filter valve should be closed to enter the next level of solution. All shut-off valves on the equipment should be closed.

7. Water treatment filter filtration device: Start up, open the relevant gate valve of the softener, and after the softener meets the water standards, open the inlet/outlet water inlet valve (the exhaust pipe of the automatic exhaust valve will be immediately closed), and the asset will be promptly shut down.

Before starting the reverse osmosis equipment with the introduction of reverse osmosis and reverse osmosis scale inhibitors, it is necessary to check whether the total number of reverse osmosis and reverse osmosis scale inhibitors in the medical box has been taken into account, and ensure that the specified system software can only run after adding reverse osmosis and reverse osmosis scale inhibitors. After starting up, the plunger metering pump should be adjusted to introduce a certain amount within the rated current range. Check if the plunger metering pump is running normally. In case of common faults, they should be cleared before funds can be put into operation.

9. The cleaning, maintenance, and repair of system software equipment should be strictly carried out in accordance with the content of the User Manual, and it is necessary to carry out softening and medication solutions on time based on detailed information.

10. If the reverse osmosis equipment encounters common faults that are more serious in the system software, such as pressure equipment leakage or circuit failure, when decisively pressing the emergency power switch on the electrical control box, confirm the removal of common faults, and then run the equipment again.

专业水处理的疑难问题，产品选型问题，可以单击下面的微信二维码电话联系贺工在线指导，长按微信二维码可自动识别添加贺工微信沟通解决您的疑难问题